Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9
Installation Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
- Position the BCM to the vehicle.
- Attach the BCM to the hinge pillar with the integral tab.
- Install the 2 fasteners retaining the BCM to the hinge pillar.
- Install the fastener retaining the body wiring harness electrical connector to the BCM.
- Connect the body wiring harness electrical connector (1) to the BCM.
- Connect the I/P wiring harness electrical connector (1) to the BCM.
- Install the right front hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
- If installing a replacement BCM, program the BCM. Refer to Control Module References .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.