Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSGENERATOR REPLACEMENT (LLV/LLR)INSTALLATION PROCEDURE

2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure

Fig 1: View Of Generator Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Position the generator to the engine.
Install the engine lift bracket. Refer to Engine Lift Bracket Replacement or Engine Lift Bracket Replacement .

CAUTION: Refer to Fastener Caution .

Install the generator mounting bolts and tighten in sequence to 50 N.m (37 lb ft).

Fig 2: View Of Generator Wiring Components

Courtesy of GENERAL MOTORS CORP.

Connect the generator lead (5) to the generator and install the generator output BAT terminal nut (6).
Tighten the nut to 20 N.m (15 lb ft).
Press the protective boot (4) on to the generator output BAT terminal (2).
Connect the wiring harness connector (1) to the generator.
Raise and support the vehicle only high enough to access the A/C compressor through the wheelhouse. Refer to Lifting and Jacking the Vehicle .

Fig 3: View Of A/C Compressor

Courtesy of GENERAL MOTORS CORP.

Position the A/C compressor (1) to the engine.
Install the A/C compressor mounting bolts (2, 3) and tighten to 50 N.m (37 lb ft).
Attach the A/C compressor electrical connector to the bracket.
Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Install the drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement .
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.