SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY REPLACEMENT (LLV/LLR)INSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
    Fig 1: View Of Battery & Battery Retainer
    GM1313643Courtesy of GENERAL MOTORS CORP.
  1. Install the battery (4) into the lower battery box (5).
  2. Install the battery retainer (1) and washer (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the battery retainer nut (3) and tighten to 15 N.m (11 lb ft).
    4. Fig 2: View Of Battery Box
    GM1313644Courtesy of GENERAL MOTORS CORP.
  4. Install the upper battery box (2) over the battery, engage the locking tabs (1) into the lower battery box (3).
  5. Connect the battery vent duct to the upper battery box (2).
    6. Fig 3: View Of Battery Cables
    GM1313634Courtesy of GENERAL MOTORS CORP.
  6. Clean any existing corrosion from the battery terminal and battery cable using a wire brush.
  7. Connect the battery positive cable to the battery and tighten the battery cable nut (4) to 9 N.m (80 lb in).
  8. Close the protective cover (3) over the battery positive cable terminal.
  9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.