SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE REPLACEMENT (LH8)REMOVAL PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Removal Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure
    Fig 1: Battery Negative Cable
    GM1901890Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the negative battery cable clip (2) from the lower half of the battery box.
  3. Remove the negative battery cable clip (3) from the battery tray.
  4. Remove the negative battery cable integral bolt (4) from the battery tray.
    5. Fig 2: Engine Wiring Harness Electrical Connector & Battery Current Sensor
    GM1901956Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine wiring harness electrical connector (6) from the battery current sensor (5).
    6. Fig 3: Negative Battery Cable Ground Bolt
    GM1901968Courtesy of GENERAL MOTORS CORP.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the negative battery cable ground bolt (4).
  8. Remove the negative battery cable clip (2) from the engine wiring harness bracket.
  9. Lower the vehicle.
  10. Remove the negative battery cable clip (1) from the engine wiring harness bracket.
  11. Remove the negative battery cable (3) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.