Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSFRONT WHEEL SPEED SENSOR REPLACEMENTREMOVAL PROCEDURE

2009 GMC Canyon 4D Pickup, 2.9 9

Removal Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure

WARNING: Refer to Brake Dust Warning .

Fig 1: Wheel Speed Sensor Electrical Connector

GM2105755

Courtesy of GENERAL MOTORS CORP.

Within the engine compartment, disconnect the wheel speed sensor electrical connector (1).
Release the wheel speed sensor harness connector from the wheelhouse.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

Fig 2: Wheel Speed Sensor Harness Clips

GM2105757

Courtesy of GENERAL MOTORS CORP.

Release the wheel speed sensor harness clips (1) from the suspension upper control arm.

Fig 3: Wheel Speed Sensor Harness Grommet

GM2105762

Courtesy of GENERAL MOTORS CORP.

Release the wheel speed sensor harness grommet (1) from the mounting bracket.

Fig 4: Wheel Speed Sensor Harness Bracket Bolt

GM2105765

Courtesy of GENERAL MOTORS CORP.

Remove the wheel speed sensor harness bracket bolt (1).

Fig 5: Wheel Speed Sensor Bolt

GM2105767

Courtesy of GENERAL MOTORS CORP.

Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
Remove the wheel speed sensor bolt (1).

NOTE: Do not pry or lever against the wheel speed sensor to remove.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.