SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEMREPAIR INSTRUCTIONSDIGITAL RADIO ANTENNA CABLE REPLACEMENTINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
    Fig 1: View Of Coax Cable & Components (UE1)
    GM1364846Courtesy of GENERAL MOTORS CORP.
  1. Attach the existing mechanics wire to the end of the coax cable (2).
  2. Pull downward on the mechanics wire to install the cable behind the I/P.
  3. Attach the coax cable retainer (4) to the hinge pillar.
  4. Attach the coax cable retainer (3) to the I/P.
    5. Fig 2: View Of Receiver Extension Cable, Retainers, & Electrical Connector
    GM1364137Courtesy of GENERAL MOTORS CORP.
  5. Connect the digital receiver extension cable (1) to the receiver.
  6. Attach the retainers (2) to the I/P.
  7. Connect the electrical connector (3).
  8. Close the (I/P) compartment door.
  9. Attach the 3 coax cable retainers to the windshield pillar.
    10. Fig 3: View Of Digital Radio Antenna Connectors
    GM1358247Courtesy of GENERAL MOTORS CORP.
  10. Connect the digital radio antenna connectors (1).
  11. Attach the 2 upper coax cable retainers to the header panel.
  12. Install the headliner. Refer to Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Regular Cab) or Headlining Trim Panel Replacement (Crew Cab) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.