Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B0828CIRCUIT/SYSTEM TESTING
2009 GMC Canyon 4D Pickup, 2.9 9
Circuit/System Testing
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the traction control switch.
- Test for less than 5 ohms between the ground circuit terminal H and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify the scan tool BCM TCS Switch State parameter is Released.
- If not the specified value, test the signal circuit terminal J for a short to ground. If the circuit tests normal, replace the BCM.
- Install a 3A fused jumper wire between the signal circuit terminal J and the ground circuit terminal H. Verify the scan tool BCM TCS Switch State parameter is Pressed.
- If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
- Ignition ON, verify the scan tool BCM Traction Switch LED parameter is OFF.
- If not the specified value, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the BCM.
- Install a 3A fused jumper wire between the signal circuit terminal B and the ground circuit terminal H. Verify the scan tool BCM Traction Switch LED parameter is ON.
- If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the traction control switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.