Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure
- Place the wiper arms in the 1/2 wipe position.
- Turn the ignition key to the OFF position.
- Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Disconnect the electrical connector (3) for the wiper motor.
- Push the electrical harness grommet (1) through the plenum panel into the cowl.
- Remove the transmission fasteners (1, 4). Twist the transmission assembly in order to remove the transmission assembly from the cowl.
- Remove the transmission (3) from the vehicle through the access openings in the top of the cowl.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.