Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSBACKUP LAMP BULB REPLACEMENTINSTALLATION PROCEDURE

2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure

Fig 1: View Of Tail Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the bulbs to the backup lamp sockets.
Install the backup lamp rotating clockwise until the locking tab is fully seated.

Fig 2: View Of Tail Lamp Screws

Courtesy of GENERAL MOTORS CORP.

Press the tail lamp to the rear body panel until fully seated.

CAUTION: Refer to Fastener Caution .

Install the tail lamp screws (1) to the tail lamp.
Tighten: Tighten the tail lamp screws (1) to 3 N.m (26 lb in).
Close the tailgate.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.