Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2007SIERRA CLASSIC 1500 2WD V6-4.3LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULALLISON - AUTOMATIC TRANSMISSION74. INTERMEDIATE CARRIER ASSEMBLY ASSEMBLE
2007 GMC Sierra Classic 1500 2WD V6-4.3L
74. Intermediate Carrier Assembly Assemble
2007 GMC Sierra Classic 1500 2WD V6-4.3LSECTION 74. Intermediate Carrier Assembly Assemble
Intermediate Carrier Assembly Assemble
1. Position the output carrier internal gear (3) on the work table so that the outer splines are facing down.
2. Install the intermediate carrier assembly (2) into the output carrier internal gear (3). Make sure the splines are engaged.
3. Install the retaining ring (1) into the output carrier internal gear (3) so that the intermediate carrier assembly is retained.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.