SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2007SIERRA CLASSIC 1500 2WD V6-4.3LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIRFLOOR CONSOLE BEZEL REPLACEMENT (NON-LUXURY UPPER)
2007 GMC Sierra Classic 1500 2WD V6-4.3L

Floor Console Bezel Replacement (Non-Luxury Upper)

2007 GMC Sierra Classic 1500 2WD V6-4.3LSECTION Floor Console Bezel Replacement (Non-Luxury Upper)


Floor Console Bezel Replacement (Non-Luxury Upper)

Removal Procedure

1. Remove the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .




2. Insert a flat bladed tool between the Bezel assembly and the console.
3. Pry the bezel from the console outwards partially in order to gain access to the connectors.




4. Disconnect the electrical connectors (1) and (2).
5. Remove the bezel from the console.



Installation Procedure





1. Place the bezel to the console.
2. Connect the electrical connectors (1) and (2).




3. Install the bezel to the console pushing on the corners till the retainers click in place.
4. Install the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.