SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2006SIERRA 1500, 4D PICKUP, 6.0 N, PART TIMEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 GMC Sierra 1500, 4D Pickup, 6.0 N, Part Time

Installation Procedure

2006 GMC Sierra 1500, 4D Pickup, 6.0 N, Part TimeSECTION Installation Procedure
  1. Position the steering wheel control switch to the steering wheel.
    Fig 1: View Of Steering Wheel Control Switch Electrical Connector
    GM652807Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the steering wheel control switch.
  3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
  4. Install the shroud to the steering wheel.
    Fig 2: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the shroud retaining screws to the steering wheel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the steering wheel. Refer to Steering Wheel Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.