Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2006SIERRA 1500, 4D PICKUP, 6.0 N, PART TIMEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSMULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENTREMOVAL PROCEDURE
2006 GMC Sierra 1500, 4D Pickup, 6.0 N, Part Time
Removal Procedure
2006 GMC Sierra 1500, 4D Pickup, 6.0 N, Part TimeSECTION Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
CAUTION:
Refer to SIR Caution
in Cautions and Notices.
IMPORTANT:
The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.