Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2006CANYON 2WD L5-3.5L VIN 6REPAIR AND DIAGNOSISCRUISE CONTROLSENSORS AND SWITCHES - CRUISE CONTROLCLUTCH SWITCHSERVICE AND REPAIR
2006 GMC Canyon 2WD L5-3.5L VIN 6
Clutch Switch: Service and Repair
2006 GMC Canyon 2WD L5-3.5L VIN 6SECTION Service and Repair
CLUTCH PEDAL CRUISE CONTROL RELEASE SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector (4) from the clutch release switch (3).
2. Complete the following in order to remove the clutch release switch (4) from the clutch pedal bracket (1):
1. Rotate the switch (4) counterclockwise.
2. Pull the switch (4) from the retainer (5).
3. Push the locking tabs inward to release the retainer (5).
INSTALLATION PROCEDURE
1. Slide only the clutch release switch retainer (5) into the clutch pedal bracket (1), until the locking tabs are fully engaged.
2. Connect the electrical connector (4) to the clutch release switch (3).
3. Adjust the clutch release switch (3). Refer to Clutch Pedal Cruise Control Release Switch Adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.