2004 GMC Jimmy (CANADA) V6-4.3LFACTORY OEM SERVICE PROCEDURE

Window Track: Service and Repair



Window Run Channel Replacement

Removal Procedure

1. Remove the door trim panel.
2. Remove the water deflector.

Factory service manual diagram



3. Remove the bolts that retain the front run channel to the door.
4. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
5. Remove the front run channel from the door.
6. Slide the window forward.
7. Remove the bolts that retain the rear run channel to the door.
8. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
9. Remove the rear run channel from the door.


Installation Procedure


Factory service manual diagram



1. Install the rear run channel to the door.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the bolts that retain the rear run channel to the door.

Tighten the bolts to 10 N.m (88 lb in).

3. Slide the window rearward into the rear run channel.
4. Install the front run channel to the door.
5. Install the bolts that retain the front run channel to the door.

Tighten the bolts to 10 N.m (88 lb in).

6. Install the water deflector.
7. Install the door trim panel.


Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.