2004 GMC Jimmy (CANADA) V6-4.3LFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE

Factory service manual diagram



1. Disconnect the spark plug wires and ignition coil wire from the distributor.

Factory service manual diagram



2. Disconnect the camshaft position (CMP) sensor harness connector from the distributor.

Factory service manual diagram



3. Remove the distributor cap screws.

Factory service manual diagram



4. Remove the distributor cap.

Factory service manual diagram



5. Remove the rotor screws.

Factory service manual diagram



6. Remove the rotor.

Factory service manual diagram



7. Align the square slot in the reluctor wheel with the CMP sensor.

Factory service manual diagram



8. Remove the CMP screws.

Factory service manual diagram



9. Remove the CMP sensor.

INSTALLATION PROCEDURE

IMPORTANT: DO NOT use the old cap, CMP sensor, and rotor screws. Use the replacement screws that have been coated with a thread locking compound.

Factory service manual diagram



1. Insert the CMP sensor through the reluctor wheel slot.

NOTE: Refer to Fastener Notice in Service Precautions.

Factory service manual diagram



2. Install new CMP mounting screws.

Tighten
Tighten the bolts to 2.2 N.m (19 lb in).

Factory service manual diagram



3. Install the rotor onto the reluctor wheel.

Factory service manual diagram



4. Install new rotor screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).

Factory service manual diagram



5. Install the distributor cap.

Factory service manual diagram



6. Install new distributor cap screws.

Tighten
Tighten the screws to 2.4 N.m (21 lb in).

Factory service manual diagram



7. Connect the CMP sensor harness connector.

Factory service manual diagram



8. Connect the spark plug wires and ignition coil wire.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.