Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Instrument Panel (IP) - Closeout/Insulator Panel Replacement - Lower
2004 GMC Envoy 2WD L6-4.2L VIN SSECTION Instrument Panel (IP) - Closeout/Insulator Panel Replacement - Lower
Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet)
Removal Procedure
1. Remove the floor console.
2. Remove the 4 screws that retain the closeout panel to the instrument panel (IP) substrate.
3. Remove the closeout panel from the vehicle.
Installation Procedure
1. Install the closeout panel to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 4 screws that retain the closeout panel to the IP.
Tighten the screws to 1.9 Nm (17 lb in).
3. Install the floor console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.