Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2001 GMC Yukon XL K1500, 6.0 USECTION Removal Procedure
CAUTION:
Refer to SIR CAUTION in Cautions and Notices.
- Disable the SIR system. Refer to Disabling the SIR System .
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
- Loosen the 2 inflatable restraint side impact sensor fasteners (2).
- Remove the inflatable restraint side impact sensor (1) from the door (4).
- Remove the connector position assurance (CPA) (3) and disconnect the inflatable restraint side impact sensor yellow 2-way harness connector (5).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.