Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2001SAFARI VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMSUN VISORSERVICE AND REPAIR
2001 GMC Safari Van 2WD V6-4.3L VIN W
Sun Visor: Service and Repair
2001 GMC Safari Van 2WD V6-4.3L VIN WSECTION Service and Repair
Sunshade Replacement
Removal Procedure
1. Remove the sunshade retaining screws, unplug the wiring harness (if equipped).
2. Remove the sunshade from the vehicle.
Installation Procedure
1. Install the sunshade to the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the sunshade retaining screws, connect the sunshade wiring harness (if equipped).
Tighten the sunshade retaining screws to 2 Nm (18 lb.in.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.