SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 94 (ENGINE CONTROLS REMOVAL & INSTALLATION)FUEL SYSTEMS (CNG ENGINE)FUEL GAUGE SELECT SWITCHREMOVAL & INSTALLATION
1999 GMC Forward Control 5.7 R, Automatic

Removal & Installation

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable SIR system. See appropriate AIR BAG RESTRAINT SYSTEMS article in ACCESSORIES & EQUIPMENT. Remove Instrument Panel (IP) trim pad. Remove defroster grille screw. Using a flat-bladed tool, remove defroster grille from IP trim pad. Remove IP outer trim cover screws. Remove IP outer trim covers. Open glove compartment and remove right IP trim plate bezel. Remove IP trim pad screws and remove IP trim pad from IP carrier.
  2. Remove screws from IP trim plate and remove IP accessory trim plate by pulling rearward to disengage retainers. Disconnect electrical connectors from trim plate. Unsnap fuel gauge select switch from trim plate. To install, reverse removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.