Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0230: Fuel Pump Control Circuit: Description
Powertrain Control Module (PCM) provides ignition voltage to coil side of fuel pump relay. When ignition is first turned on, PCM energizes fuel pump relay, which applies power to fuel pump. The PCM enables fuel pump relay as long as engine is cranking or running, and crankshaft reference pulses are received. If no crankshaft reference pulses are received, PCM de-energizes fuel pump relay after 2 seconds. The PCM monitors voltage on fuel pump relay control circuit. DTC P0230 will set if PCM detects an incorrect voltage on fuel injector control circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.