SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 867 (FRONT SUSPENSION)REPAIR INSTRUCTIONSWHEEL BEARING/HUB REPLACEMENT - FRONTREMOVAL PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Brake Rotor
    GM931367Courtesy of GENERAL MOTORS CORP.
  1. Remove the front brake rotor. Refer to FRONT BRAKE ROTOR in Disc Brakes.
    2. Fig 2: Front Wheel Speed Sensor
    GM926677Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wheel speed sensor electrical connector, if equipped.
    3. Fig 3: Wheel Speed Sensor Electrical Connector & Connector Bracket
    GM931451Courtesy of GENERAL MOTORS CORP.
  3. Remove the wheel speed sensor electrical connector form the connector bracket.
    4. Fig 4: Front Wheel Drive Shaft Spindle & Nut
    GM933045Courtesy of GENERAL MOTORS CORP.
  4. Remove the front wheel drive shaft spindle nut.
    5. Fig 5: View Of Wheel Bearing/Hub Assembly & Mounting Bolts
    GM933099Courtesy of GENERAL MOTORS CORP.
  5. Support the wheel drive shaft with heavy mechanic's wire or equivalent.
  6. Remove and discard the wheel bearing/hub mounting bolts.
  7. Remove the wheel bearing/hub assembly from the steering knuckle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.