Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hood Hinge Cable
    GM930888Courtesy of GENERAL MOTORS CORP.
  1. Install the hood hinge cable and grommet through the front of the dash.
  2. Slide the hood release handle into the hinge pillar and secure into place.
  3. Fig 2: View Of Center Pillar Lower Garnish Molding
    GM965599Courtesy of GENERAL MOTORS CORP.
  4. Move carpet back into position and install the front carpet retainer. Refer to Carpet Retainer Replacement - Front in Interior Trim.
  5. Fig 3: Latch Release Cable
    GM930872Courtesy of GENERAL MOTORS CORP.
  6. Route the hood cable through the body structure.
  7. Install the hood latch. Refer to Hood Latch ReplacementΒ .
  8. Inspect the hood latch cable for proper operation.
  9. Close the hood.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.