Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 856 (BODY FRONT END)REPAIR INSTRUCTIONSFENDER REPLACEMENT - FRONTREMOVAL PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front .
Remove the rocker panel molding. Refer to Molding Replacement - Rocker Panel in Exterior Trim.
Remove the mirror applique. Refer to Applique Replacement - Windshield Frame in Exterior Trim.
Remove the windshield frame applique. Refer to Applique Replacement - Windshield Frame in Exterior Trim.
Remove the side marker lamp assembly. Refer to Marker Lamp Replacement - Side in Lighting Systems.

Fig 1: Front Fender

Courtesy of GENERAL MOTORS CORP.

Remove the bolts and nuts from the bottom, front, and top of the fender.
Remove antenna mast, if equipped. Refer to Fixed Antenna Mast Replacement in Entertainment.
Remove the fender from the vehicle.
If the fender requires replacement, remove the following components:
- The fender emblem. Refer to Emblem/Nameplate Replacement - Front Fender in Exterior Trim.
- The fender brace. Refer to Fender Extension Bracket Replacement - Front .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.