Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 85 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 2.2L)DIAGNOSTIC TESTSDTC P0327: KNOCK SENSOR CIRCUITDTC PARAMETERS
1999 GMC Forward Control 5.7 R, Automatic
DTC Parameters
1999 GMC Forward Control 5.7 R, AutomaticSECTION DTC Parameters
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Engine speed 1800-2400 RPM.
- Engine run time more than 20 seconds.
- ECT more than 158°F (70°C).
- MAP more than 35 kPa.
- No TP sensor-related DTCs set.
DTC sets when ECM detects no normal or low knock sensor activity for more than 15 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.