Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lift gate applique. Refer to Liftgate Applique Replacement in Body Rear End.
  2. Remove the rear wiper arm. Refer to Wiper Arm Replacement - Rear in Wiper/Washer Systems.
  3. Remove the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate in Body Rear End.
  4. Remove the rear wiper module. Refer to Wiper Motor Replacement - Liftgate in Wiper/Washer Systems.
  5. CAUTION: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.