Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Seat Bucket
    GM986799Courtesy of GENERAL MOTORS CORP.
  1. Position the seat fully forward.
  2. Disconnect the shoulder belt from the seat quick disconnect feature by using a flat-bladed tool to press the tab.
  3. Fig 2: Front Seat Adjuster Bolts
    GM981927Courtesy of GENERAL MOTORS CORP.
  4. Remove the front seat adjuster bolts.
  5. Move the seat to the full rearward position.
  6. Fig 3: Disconnecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the seat electrical connectors.
  8. Lift the front seat adjuster hooks from the floor pan.
  9. Remove the seat from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.