Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 842 (SEATS)REPAIR INSTRUCTIONSSEAT BACK LATCH RELEASE CABLE REPLACEMENT - REARREMOVAL PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Fastener From Rear Seat Back Latch

GM982101

Courtesy of GENERAL MOTORS CORP.

Remove the fastener from the rear seat back latch and pull the latch out from the seat back assembly.

Fig 2: Seat Back Recliner Handle & Cable

GM986676

Courtesy of GENERAL MOTORS CORP.

Detach the latch cable from the latch.

Fig 3: Disconnecting Latch Cable

GM986321

Courtesy of GENERAL MOTORS CORP.

If you are going to replace the cable, disconnect the latch cable at the seat recliner mechanism.

Fig 4: View Of Lower J-Hook Retainer

GM981476

Courtesy of GENERAL MOTORS CORP.

Open the J-strip at the bottom of the seat cover.

Fig 5: Replacing Cable Out Of Seat Back Assembly

GM986695

Courtesy of GENERAL MOTORS CORP.

Pull the cable out from the seat back assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.