Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0719: Brake Switch Circuit High: Description
The stoplight switch is used to turn On the stoplights and serve as a brake pedal input to the PCM. The stoplight switch contact is closed with the brake pedal depressed and switch adjusted properly. Ignition voltage is supplied to the PCM through the stoplight switch whenever the ignition is turned ON and the brake pedal is depressed. When the brake pedal is released, the PCM brake switch input goes low. The PCM monitors the brake switch input for low and high voltage faults under certain conditions. DTC P0719 sets when the vehicle has accelerated a set number of times and the voltage at the PCM remains high, indicating the brake pedal is always being applied.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.