SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 767 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE CALIPER BRACKET REPLACEMENT - REARINSTALLATION PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Bracket Bolts (1)
    GM450514Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper bracket to the suspension knuckle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the two NEW brake caliper mounting bracket bolts (1) and washers.

    The new brake caliper mounting bracket bolts will come with an adhesive already applied to the threads.

    Tighten:  Tighten the brake caliper mounting bracket bolts to 175 N.m (125 lb ft).

  3. Lubricate the brake caliper pin bolts with high temperature silicone lubricant.
    4. Fig 2: Removing/Installing Front Brake Pads
    GM727773Courtesy of GENERAL MOTORS CORP.
  4. Install the brake pad retainers (2) to the brake caliper bracket (3).
  5. Install the brake pads (1) to the brake caliper bracket (3).
  6. Install the brake caliper. Refer to Brake Caliper Replacement - Rear .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.