Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and position the convertible top with the 1 and 5 bows upright.
    Fig 1: Folding Top With The #1 Bow And The #5 Bow Up
    GM289910Courtesy of GENERAL MOTORS CORP.
  2. Raise or leave raised, the folding top stowage compartment lid.
  3. Fig 2: Rear Compartment Right Side Trim Panel
    GM214022Courtesy of GENERAL MOTORS CORP.
  4. Remove the push-in fastener from the rear compartment side trim panel.
  5. Remove the rear compartment side trim panel.
  6. Fig 3: Electrical/Audio Connector At Rear Speaker & Screws
    GM214776Courtesy of GENERAL MOTORS CORP.
  7. Remove the rear speaker retaining screws.
  8. Begin to remove the rear speaker in order to access the electrical/audio connector.
  9. Disconnect the electrical/audio connector from the rear speaker.
  10. Remove the rear speaker.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.