Compressor Control Valve Assembly Install (V5 - Conventional Mount)

1999 GMC Forward Control 5.7 R, AutomaticSECTION Compressor Control Valve Assembly Install (V5 - Conventional Mount)
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 5403  Snap Ring Pliers

  1. Coat the O-rings with 525 viscosity refrigeration oil.
  2. Using thumb pressure, push the O-rings in place.
  3. Install the valve into the case.

    Important:  Ensure that the retaining ring is properly seated in the ring groove.

  4. Using the J 5403  , install the valve retaining ring (5) with the high point of the curved sides against the valve housing.
  5. Perform a leak test. Refer to Compressor Leak Testing (V5 - Conventional Mount)  or Compressor Leak Testing (V5 Direct Mount) .
    Fig 1: Valve Retaining Ring
    G01672583Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.