SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 706 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK REPLACEMENT - FRONTINSTALLATION PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front seat back to the front seat.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the recliner to seat frame pivot bolts.

    Tighten 

    Tighten the recliner to seat frame pivot bolts to 24 N.m (18 lb in).

  3. Install the new roll pins to the hinge supports and recliner.
  4. Fasten the J-retainer on the outboard side of the seat cushion cover.
  5. Connect the electrical connectors, as needed.
  6. Install the front seat trim panel. Refer to TRIM PANEL REPLACEMENT - FRONT SEAT  .
  7. Install the front seat. Refer to SEAT REPLACEMENT - FRONT BUCKET  .
    Fig 1: Installing Front Seat Back To Front Seat
    G01504363Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.