Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the push-in retainer on the front track cover using J 38778Β  .
  2. Remove the front track cover.
    Fig 1: Removing Push-In Retainer On Front Track Cover Using J 38778
    G01504395Courtesy of GENERAL MOTORS CORP.
  3. For manual seat adjusters only, remove the track cover screw from the rear of the adjusters.
    Fig 2: Removing Track Cover Screw From Rear Of Adjusters
    G01504396Courtesy of GENERAL MOTORS CORP.
  4. For power adjusters only, unsnap the track covers from the rear of the adjusters.
    Fig 3: Removing Track Covers From Rear Of Adjusters
    G01504397Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.