Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood hinge to the fender.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the hood hinge to the fender bolts.

    Tighten 

    Tighten the hood hinge to fender bolts to 25 N.m (18 lb ft).

  3. Install the rear hood side seal. Refer to SEAL REPLACEMENT - HOOD REAR SIDE  .
  4. Install the hood assist rod. Refer to ASSIST ROD REPLACEMENT - HOOD  .
  5. Install the hood. Refer to HOOD REPLACEMENT  .
  6. Adjust the hood as required. Refer to HOOD ADJUSTMENT  .
    Fig 1: Installing Hood Hinge To Fender Bolts
    G01503963Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.