Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 68 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.1L ENGINE)DIAGNOSTIC TESTSDTC P0507: IDLE SPEED - HIGHCONDITIONS FOR RUNNING DTC
1999 GMC Forward Control 5.7 R, Automatic
Conditions For Running DTC
1999 GMC Forward Control 5.7 R, AutomaticSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Malibu, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0401, P0403, P0404, P0405, P0443, P1121, P1404, and P1441 are not set.
- The engine run time is more than 2 minutes.
- The Engine Coolant Temperature (ECT) sensor is more than 158°F (70°C).
- The Intake Air Temperature (IAT) sensor is more than -0.4°F (-18°C).
- The Barometric Pressure (BARO) sensor is more than 70 kPa.
- The ignition voltage is 9-18 volts.
- The Throttle Position (TP) sensor angle is less than 1.5 percent.
- The Vehicle Speed Sensor (VSS) sensor is less than 3 MPH.
- The above conditions are met for more than 8 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.