Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 659 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PRESSURE HOSE REPLACEMENT (3.8L)INSTALLATION PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the power steering pressure hose to the vehicle.
Install the power steering pressure hose (2) to the clamps (1) on the power steering gear.
NOTE: Refer to FASTENER NOTICE .
Install the power steering pressure hose to the power steering pump.
Tighten

Tighten the fitting to 27 N.m (20 lb ft).
Install the power steering pressure hose to the power steering gear.
Tighten

Tighten the pressure hose fitting to 27 N.m (20 lb ft).

Fig 1: Installing Power Steering Pressure Hose (3.8L)
Courtesy of GENERAL MOTORS CORP.
Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
Remove the drain pan from under the vehicle.
Lower the vehicle.
Install the accessory drive belt. Refer to DRIVE BELT REPLACEMENT (L36) or DRIVE BELT REPLACEMENT (L67) .
Fill the power steering system with power steering fluid. Refer to Checking and Adding Power Steering Fluid .
Bleed the power steering system. Refer to Bleeding the Power Steering System .
Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.