Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (ELECTRICAL COMPONENT LOCATOR)BUZZERS, RELAYS & TIMERS
1999 GMC Forward Control 5.7 R, Automatic
Buzzers, Relays & Timers
1999 GMC Forward Control 5.7 R, AutomaticSECTION Buzzers, Relays & Timers
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
BUZZERS, RELAYS & TIMERS LOCATION
| Component | Location |
|---|---|
| Back-Up Lamp Relay | Behind left side of dash, mounted to multi-purpose bracket near BCM. See Figure . |
| Headlamp Relay | Behind glove box, mounted to underside of cross-car beam. See Figure . |
| Park Lamp Relay | Behind right side of dash, on cross-car beam. |
| Rear Compartment Lid Release Relay | Behind glove box, mounted to underside of cross-car beam. See Figure . |
| Rear Window Defogger Relay | Behind glove box, mounted to underside of cross-car beam. See Figure . |
| Retained Accessory Power (RAP) Relay | Behind glove box, mounted to underside of cross-car beam. See Figure . |
| Turn Signal/Hazard Flasher Module | Below left side of dash, mounted on multi-purpose bracket near BCM. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.