Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 574 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSMUFFLER REPLACEMENTINSTALLATION PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic
Installation Procedure
1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the muffler over the rear axle and towards the rear of the vehicle.
- Install the exhaust hanger insulators to the muffler.
- If the vehicle is equipped with AWD, use the utility stand to raise and install the crossmember. Refer to Crossmember Replacement in Frame and Underbody.
- Install a new catalytic converter gasket.
- Install the catalytic converter bolts.
Tighten: Tighten the catalytic converter bolts to 45 N.m (33 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.