Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wiper arm. Refer to Wiper Arm Replacement - RearΒ .
  2. Fig 1: View Of Rear Wiper Motor Components
    GM755866Courtesy of GENERAL MOTORS CORP.
  3. Remove the seal from the wiper motor driveshaft.
  4. Remove the liftgate access trim panel.
  5. Remove the rear wiper motor screws.
  6. Disconnect the rear wiper motor electrical connector.
  7. Remove the rear wiper motor from the liftgate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.