Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 554 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT CUSHION FRAME REPLACEMENT - FRONT (AZTEK)REMOVAL PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Underside Of Front Bucket Seat

Courtesy of GENERAL MOTORS CORP.

Remove the front bucket seat from the vehicle. Refer to Seat Replacement - Bucket .
Remove the front seat adjuster. Refer to Seat Adjuster Replacement - Front .
Remove the front seat back from the front seat. Refer to Seat Back Replacement - Front .

IMPORTANT: Remove the front seat cushion cover and the cushion as one piece.

Remove the front seat cushion cover from the front seat cushion. Refer to Seat Cushion Cover Replacement - Front (Aztek) .
Remove the front seat cushion from the front seat frame. Refer to Seat Cushion Replacement - Front (Aztek) .
Disconnect all required wiring harnesses from the front seat cushion frame.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.