SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 554 (SEAT SYSTEM)REPAIR INSTRUCTIONSARMREST REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Front Bucket Seat Armrest
    GM626885Courtesy of GENERAL MOTORS CORP.
  1. Position the bolt into the mounting point of the armrest.
    2. Fig 2: Locating Front Bucket Seat Armrest Bolt
    GM626879Courtesy of GENERAL MOTORS CORP.
  2. Position the armrest to the front bucker seat.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the armrest mounting bolt.

    Tighten:  Tighten the armrest mounting bolt to 4.5 N.m (40 lb in).

    4. IMPORTANT: Rotate the armrest bolt trim cap to a new position to allow the retainer on the cap to seat properly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.