Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 533 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSLICENSE LAMP REPLACEMENT (RENDEZVOUS)REMOVAL PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic
Removal Procedure
1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear lift gate applique. Refer to Liftgate Applique Replacement in Body Rear End.
- Remove the license plate lamp from the applique by pulling rearward from the applique.
- Remove the license plate lamp socket, turning counterclockwise.
- Remove the license plate lamp bulb from the license plate lamp socket, if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.