Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 525 (BODY REAR END)REPAIR INSTRUCTIONSEND GATE COVER REPLACEMENTREMOVAL PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the handle from the handle assembly. Refer to HANDLE REPLACEMENT - REAR DOOR INSIDE .
Remove the endgate trim panel. Refer to TRIM PANEL REPLACEMENT - END GATE .
Remove the endgate bellcrank rod from the endgate inside handle assembly.
Remove the screws that retain the endgate cover to the endgate.
Remove the endgate cover from the endgate.
Release the endgate latch rods from the latch rod clips.

Fig 1: Removing Endgate Cover From Endgate
Courtesy of GENERAL MOTORS CORP.
Drill out the rivets that secure the handle assembly to the endgate.
Remove the handle from the endgate cover.

Fig 2: Removing Handle From Endgate Cover
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.