Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 501 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSUPPER CONTROL ARM BUSHINGS REPLACEMENT (RWD)INSTALLATION PROCEDURE

1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the upper control arm shaft to the upper control arm.
Install the control arm bushings to the upper control arm. Use the J 22269-01 and a short piece of pipe that is the same outer diameter as the rubber bushing.

Fig 1: Installing Upper Control Arm Shaft To Upper Control Arm
Courtesy of GENERAL MOTORS CORP.
Tighten J 22269-01 until the bushing is positioned on the shaft and the upper control arm as shown. The measurement should be 12.8-13.8 mm (0.48-0.52 in) on both ends.

Fig 2: Upper Control Arm Bushings
Courtesy of GENERAL MOTORS CORP.
Install the washers and the nuts to the upper control arm shaft. Do not tighten the nuts.
Remove the upper control arm from the vise.
Install the upper control arm to the vehicle. Refer to UPPER CONTROL ARM REPLACEMENT (RWD) or UPPER CONTROL ARM REPLACEMENT (4WD) .

Fig 3: Installing Washers & Nuts To Upper Control Arm Shaft
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.