SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 395 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENT (LX5)REMOVAL PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle.
  2. Remove the fuel injector site shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT in Engine Mechanical-3.5L.
  3. Remove the power steering pump pulley from the power steering pump. Refer to Power Steering Pulley Replacement (LX5)  or Power Steering Pulley Replacement (L47)  .
  4. Remove the power steering pump pressure hose (1) from the power steering pump.
    Fig 1: Removing Power Steering Pump Pressure Hose
    G01581718Courtesy of GENERAL MOTORS CORP.
  5. Remove the power steering pump return hose from the power steering pump.
    Fig 2: Removing Power Steering Pump Return Hose
    G01581719Courtesy of GENERAL MOTORS CORP.
  6. Remove the power steering pump mounting bolts.
  7. Remove the power steering pump.
  8. Remove the power steering pump reservoir from the power steering pump. Refer to Power Steering Reservoir Replacement - Off Vehicle .
    Fig 3: Removing Power Steering Pump
    G01581720Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.