Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear passenger seats as needed. Refer to SEAT REPLACEMENT - REAR BENCH (ALL EXCEPT LUXURY) or SEAT REPLACEMENT - REAR BENCH (LUXURY Y91) .
  2. Remove the passenger side rear corner trim panel. Refer to Trim Panel Replacement - Right Rear CornerΒ .
  3. Grasp and gently pull the passenger side body side trim panel in order to disengage the retaining clips.
  4. Remove the passenger side body side trim panel from the vehicle.
  5. Inspect the passenger side body side trim panel for broken or missing retaining clips. Replace the clips as needed.
    Fig 1: Removing Passenger Side Body Side Trim Panel
    G01737383Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.