Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 365 (ENGINE MECHANICAL - 3.8L (UNIT REPAIR))REPAIR INSTRUCTIONSOIL LEVEL INDICATOR AND TUBE INSTALLATION
1999 GMC Forward Control 5.7 R, Automatic
Oil Level Indicator and Tube Installation
1999 GMC Forward Control 5.7 R, AutomaticSECTION Oil Level Indicator and Tube Installation
WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Install the oil level indicator tube.
- Lubricate the O-ring with engine oil and make sure it is in place.
- Make sure the assembly is fully seated in the engine block.
- Install the oil level indicator tube nut.
Tighten:
Tighten the nut to 19 N.m (14 lb ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.