SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 357 (STEERING WHEEL AND STEERING COLUMN)REPAIR INSTRUCTIONSSTEERING WHEEL REPLACEMENTREMOVAL PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Removal Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Turn OFF the ignition.
  3. Remove the Inflatable restraint steering wheel module.
  4. Scribe an alignment mark on the steering wheel hub. Align the mark with the slash mark on the steering shaft.
  5. Loosen the steering wheel nut.
    Fig 1: Steering Wheel Nut
    G01720255Courtesy of GENERAL MOTORS CORP.
  6. Position the steering wheel nut flush with the end of the steering shaft.
  7. Assemble J 1859-A  with J 42578  on the steering wheel.
  8. Use J 1859-A  with J 42578  in order to unseat the steering wheel from the steering shaft.
  9. Remove J 1859-A  and J 42578  from the steering wheel.
  10. Remove the steering shaft nut.
  11. Remove the steering wheel from the steering shaft.
    Fig 2: Removing Steering Wheel From Steering Shaft
    G01720256Courtesy of GENERAL MOTORS CORP.
  12. Unroute the SIR connector from the steering wheel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.