SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 347 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL STUD REPLACEMENTINSTALLATION PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic

Installation Procedure

1999 GMC Forward Control 5.7 R, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a new stud in the wheel hub.
  2. Place some washers (1) onto the wheel stud (3). See Fig 1.
    NOTE: Make sure that the wheel stud is fully seated against the wheel hub flange.
  3. With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
  4. Remove the wheel nut and washers.
  5. Install the rear wheel hub/speed sensor assembly into the suspension knuckle. Refer to WHEEL BEARING/HUB REPLACEMENT - REAR .
  6. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS article.
  7. Lower the vehicle.
Fig 1: Placing Washers & Wheel Nut Onto Wheel Stud
G00371773Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.